Icon Collap

CIMON FAQs Customer Support

Trang chủ » Tất cả FAQ » Liên kết Cimon-PLC qua giao thức Ethernet

Liên kết Cimon-PLC qua giao thức Ethernet

14/12/2018 294

Liên kết Cimon-PLC qua giao thức Ethernet?

Q: How to Use and Configure CIMON PLC Link protocols via Ethernet?

A: There are three types of CIMON PLC Link protocols which support Peer to  Peer communication for CIMON PLCs (CM1 and CM3) via Ethernet.

+ PLC Link (CIMON-Dedicated) Protocol – Max No. is 64 device.
+ PLC Link (Public) Protocol – Max No. is 64 device.
+ High Speed Link Protocol – Max No. is 64 device.

※ CM1-EC10A – Max. supported Node number is 16.
※ CM1-EC01A – Max. supported Node number is 6.
※ CM3-SP01EET – Max. supported Node number is 16.

1. PLC Link (CIMON-Dedicated)

– This protocol only supports EC01A (CM1 Series).
– This protocol can be used only within one identical Network (Local to Expansion).
– Does NOT require to configure IP Address for each of multiple Ethernet modules.
– Can communicate by assigning a station for each of multiple Ethernet modules.
– Go to CICON Parameter on Project Window -> PLC Link -> Configure a Frame (SEND / REC)

2. PLC Link (Public)

– This protocol only supports EC01A, EC10A (CM1 Series).
– Communicates between same or other networks (Local to Local, Local to Expansion).
– Must require both IP Address and Station for each Ethernet module.
– Configure a special program named “PLC Link (Public IP) Setting” as shown below and assign an IP Address for each Ethernet module.

  • Go to CICON Parameter -> PLC Link -> Configure a Frame (SEND / RECEIVE) in the same
    manner as that of PLC Link (CIMON-Dedicated)

3. High Speed Link (Ethernet)

– Supports CM1 and CM3 Series.
– Supports between PLC-S CPUs (SP01EET included), between EC10As, and between PLC-S and EC10A.
– NOT support EC01A module.
– This protocol can be used only within one identical Network (Local to Expansion).
– Does NOT require to configure IP Address for each of multiple Ethernet modules.
– Needs to configure Local/Expansion, Slot#, and Station in High Speed Link program.
– Configure a special program named “High Speed Link(E)” and set up Ethernet module and Frame in CICON as shown below.

Chia sẻ:
Contact Us

We provides the best service for customer satisfaction.

We will respond promptly to your inquiries.